Using a hole to create a well and a drain
At your summer cottage it is necessary to equip an independent source of water. It can be an ordinary well or a well. In any case, you will have to drill. In principle, if the groundwater level is not very deep, then you can do the usual digging, but this solution will be normal only when the depth to the water is no more than 15 meters. And even then, if there is no stone and other hard rock in the earth.
For a well, as a rule, the depth is approximately 40 meters. Drilling is done with special equipment. Renting a pit house is very expensive, so it is very important to prepare the site in advance. The drilling process itself takes little time, the total time is most affected by the depth, as well as rocks that exist in the ground. For example, the same stone can be broken only with the use of a diamond drill.
Also, in addition to the well, you will need a drain and a fence. They are also the easiest to make with the help of yamobura.It is recommended to first drill holes under the pillars. After installing the pile, you can perform the main drilling. Thus, a stable structure will be obtained, which over time will not be eroded by runoff and subside.
It should be borne in mind that drilling can be done not at all sites. Therefore, if you doubt this, it is better to immediately perform a geological analysis. This is necessary if there is a likelihood of finding sandstones in land deposits. If they are, then drilling to a greater depth will not give results. Just a hole or well will constantly collapse. In such cases, it is necessary to perform sequential drilling with reinforcement of the walls. Conventional concrete rings are perfect for such purposes.
Consider that in the case of drilling a stone, it is necessary to pour water into the pit so that the hole does not break down - take care of the water in advance.